Bosch dishwasher E22 code

Good writeup here.

Short answer - clean the bottom filter.

Comments

Post a Comment

Popular posts from this blog

Wiring an ecobee3 without the G wire (G-wire, fan wire)

Note: this post has nothing to do with the dreaded "C-wire" that is required to run an ecobee.  If you're looking for that, go elsewhere. One of the more frustrating items for a heating/cooling system is the sheer number of possible ways to set it up.  Sure, there are "standard" ways, but there are also always other ways. We had a new furnace installed not long ago.  However, there were not enough wires run to the thermostat to support the additional A/C system.  The cable had only enough wires for heat-only operation. To make it work, the installers should have run a new cable, but they didn't.  Instead, they disconnected the G (fan) wire, and used it for Y (cold call) instead.  This led to an atypical installation that lacked a G (fan) wire at the thermostat. Note it still worked.  The thermostat sent the W (heat) and Y (cold) signals, and the furnace controlled its own fan.  No worries, thanks to them thar new-fangled furnace, y'all. ...
Read more

Hiren's Boot CD HBCD menu missing when booting on Vaio Z3

I wanted to back up my Z3 using Hiren's Boot CD .  I have done this before, and it worked well. (I recommend Image For Windows, available on Hiren's, but you should buy a licence.  IFW seems to be one of the only programs out there that can actually do a bare metal restore.) Oddly enough, when I booted the Z from the USB stick, I did not see Image for Windows.  In fact, I did not see any programs at all.  Mini Windows XP ran fine, but all the programs were missing! Scrounging around the File Manager turned up nada.  It looked like the USB stick was not there, even though the machine had booted from it just fine. The conflict in my case was an SD card that I had added to the system.  It seems Mini XP got confused after boot and replaced the USB stick drive with the SD card.  XP was not capable of reading the SD card owing to the large capacity, and essentially got stuck, unable to locate or load any of the Hiren's apps. Removing the SD card (a...
Read more

How to fix Lexus / Toyota "AWD system malfunction 2WD mode engaged"

May be associated with other errors, such as "Check Engine" light, ICS / backup system warning, etc.  Simple fixes that may save you time/money: 1.  Check gas cap is tight. Yes, it's stupid - damn stupid, in fact.  But it worked for me and others . Note the old RX330s had a similar issue, in that it would throw error codes if the gas cap was loose.  Happened to me a few time when the weather got really cold.  It's all because the car is looking for leaks in the emissions control system and sees that the pressure in the gas tank is not holding steady. 2.  If codes do not clear themselves, disconnect battery for 5 min, then reconnect and start. •  Open the door during that 5+ min, to ensure system is fully discharged.  Not needed but can't hurt. •  Yellow ICS light (top right-hand corner on RX350) will flash on restart.  It will self-reset upon driving, don't worry about it. 3.  Recharge battery to full, then retry.  Worked for h...
Read more